Usbcore: registered new interface driver usbserial_genericĬongratulations, your link is up - in this example, the device can be used on /dev/ttyUSB0. Usb 1-1: generic converter now attached to ttyUSB0 Usbserial_generic 1-1:1.0: generic converter detected Near the end, you should see something like: Sudo modprobe usbserial vendor=0x4348 product=0x5523įinally, check dmesg again to ensure it loaded properly. Now, we can load up the driver for this device: Which returns the summary list again, but now showing the new USB device: Now, plug the device back in, and run lsusb again: You will see a summary list of your USB devices on the system, I only have one: The easiest way to find the information is to first unplug the device, then run lsusb: Now, we need to figure out the device vendor number and product number to tell the usbserial driver. Usb 1-1: configuration #1 chosen from 1 choice Usb 1-1: new full speed USB device using uhci_and address 2 Torward the end of the messages, you should see this: After plugging in the device, first check the hardware messages to see the device was detected: If you are using the usb -> RS232 adapter, the serial drivers may need to be installed for the device to work properly. The procedure for using the USB adapter from the BOM wasn't in the wiki - nor was it immediately obvious, so, here goes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |